Start by requesting the new DNS name and IP address from your network administrator. The IP address you request must be in the same subnet as the existing IP address on your server.
If you use proxy by hostname, be sure to request the creation of the wildcard entry to point to the same address. With proxy by hostname, you should also verify that the DNS entries with the Check DNS test.
In this note, the DNS name ezproxy.yourlib.org and the IP address 126.96.36.199 demonstrate where the DNS name and IP address should appear, and where you should insert your values instead.
These are the steps to add the second IP address to your existing network adapter.
- Use the Start menu to open Control Panel.
- On Windows XP, you may need to open Network and Internet Connections.
- Open Network (and Dial-up) Connections.
- Open your network adapter.
- Click Properties.
- Click Internet Protocol (TCP/IP) then click Properties.
- Click Advanced.
- On the IP Settings tab, click Add...
- Type in the new IP address then click Add.
- Click OK to close the Advanced TCP/IP settings window.
- Click OK to close the Internet Protocol (TCP/IP) Properties window.
- Click OK to close your network adapter properties window.
To tell EZproxy to use this name and address, edit config.txt and add lines similar to:
Name ezproxy.yourlib.org Interface 188.8.131.52
These lines should appear before any LoginPort, LoginPortSSL, or Title lines.
Note: EZproxy is no longer supported on a server also running IIS.